Underwater Camera With Built-in Zoom Lens

Underwater camera is the biggest feature of pure waterproof, it is the biggest difference with the ordinary camera is the main part of the seams are sealed with silicone and rubber seal, the internal structure of the device and the general camera is no different, but the underwater camera can only Using built-in zoom lens, unlike ordinary cameras have built-in and external zoom lens two, after all, Underwater Camera external zoom lens is better than the built-in zoom lens, but underwater camera can shoot in the rain. Rain is also a good photographic theme. In short, both pros and cons, but for the usual shooting is not serious

How does underwater camera use?

1: Be sure to turn on the machine before opening the machine switch button, do not underwater switch machine operation, this will make the water through the power switch button to enter the motherboard. Underwater Camera If the water is long because there is no operation, the machine automatically shut down, please obediently float to the surface and then open the boot button!

2: before the water, please carefully check the camera's battery compartment plastic is good, and pay attention to the yellow seal on the seal above the sticky sand, hair, or unknown particles, Underwater Camera and to ensure that the plastic smoothing smooth no debris, and then turn off the battery warehouse. (Data line warehouse also available)

3: into the water, before the camera, please wrist sets tight wrist rope, to avoid the waves or accidentally lead to the camera into the deep sea, Underwater Camera in addition to hold the underwater camera plastic anti-skid area.

4: Underwater shooting, please use the underwater mode (a small fish logo mode), underwater mode there is an underwater macro mode, shoot shrimp and small fish, seaweed leaves can use this model. Because the sea is blue, if not underwater mode, is blue into a paste. Underwater mode automatically fill red light, so that the color reproduction of the photo higher and more clear.

5: out of the camera out of the water, please put the camera inside the water soak for 20 minutes, so that salt dilution, or salt particles in the operation of the key in the gap, Underwater Camera resulting in operational key failure.

6: take the battery, please ensure that the battery opening down (to avoid the water poured into the battery compartment, this is critical, into a little bit of water, may lead to motherboard problems), with a rag to the battery compartment around the water wipe clean, And then open the battery down, remove the battery, do not worry about shut down the battery compartment, so that the battery compartment open down, dry for a while and then the next operation.