The Protection Capability Of Underwater Camera System Is Quite Strong
Leave a message
Underwater camera system is the biggest feature of pure waterproof, it is the biggest difference with ordinary cameras is the main joint part with silicone and rubber seals sealed dead, the internal structure of the device and the ordinary camera is not different, but the underwater camera can only use the built-in zoom lens, Underwater Camera System unlike ordinary cameras have built-in and external zoom lens two, after all, the external zoom lens is better than the built-in zoom lens, but the underwater camera system can be filmed in the rain. Rain is also a good photographic subject.
The underwater camera system itself mainly uses Shell + movement design, because the shell itself is waterproof and pressure-resistant structure, so you can use no other protection, Underwater Camera System directly for diving photography. Of course, also because of this characteristic, the metal enclosure's protection ability is quite strong, the general bad weather simply is nothing. If you are installing an amphibious lens, you can usually use it very rough.
How to use underwater camera system?
: Be sure to open the machine before launching the switch button, do not under the water switch operation, this will make water through the power switch button into the motherboard. If because the underwater time is long no operation, the machine shuts down automatically, please obediently floats to the surface and opens the boot button! 2: Before launching, please carefully check the camera's battery compartment plastic seal is intact, Underwater Camera System and pay attention to the yellow sealing plastic seals above the fine sand, hair silk, or unknown particulate matter, and ensure that the plastic sealing light smooth without debris, and then close the battery compartment. (Data silos are similarly available)
3: Enter the water, before filming please wrist strap tight wrist rope, to avoid the waves or their careless cause the camera into the deep sea, in addition, Underwater Camera System please hold the underwater camera plastic non-slip area. 4: Underwater shooting, please use the model (there is a small fish sign pattern), Underwater mode also has a macro mode underwater, shrimp and small fish, seaweed leaves can be used in this mode. Because the sea is blue, if not under the water mode, is blue into a piece of paste. Underwater Camera System The underwater mode automatically complements the red light, allowing the color reduction of the photo to be higher and clearer.
5: Use the camera out of the water, please put the camera in the water to soak for 20 minutes, so that the salt dilution, otherwise salt card in the gap in the Operation key, resulting in the Operation key failure. 6: When the battery is taken, please ensure that the battery openings down (avoid water intrusion into the battery compartment, this is very critical, into a little water, may lead to the motherboard problem, Underwater Camera System with a rag to the battery around the drops wipe clean, and then open the battery to take out the battery, do not worry about closing the battery compartment, let the battery openings down, dry a while to do the next operation.






