Basic Parameters Of Underwater Lamp

Underwater lamp is a low water, the simple means is installed in the water of the lamp, the appearance of small and exquisite, elegant appearance, and some buried lights, just a few more installed chassis, the chassis is fixed with screws.

Because the underwater lamp is used under the bottom, the need to withstand a certain pressure, so the general use of stainless steel materials, 8-10mm tempered glass, Underwater Lamp high-quality waterproof joint, silicone rubber seal ring, curved multi-angle refraction reinforced glass, waterproof, dustproof, leakage, corrosion resistance.

1. Underwater lamp is an LED for the light source, by the red, green, blue composition of the color changes in the mix of underwater lighting is the fountain, theme parks, exhibitions, Underwater Lamp commercial and artistic lighting perfect choice. In order to make the LED underwater lamp better cooling, it is advisable to put the luminaire on the water below.

2. The water lamp waterproof effect achieves IP65, because has the very good waterproof effect, the lamp can put on from the water surface 5 meters. The best angle of projection is 25. Underwater Lamp Controller control to achieve synchronization effect, and access to DMX console, each unit set up a separate address, red, green, blue light respectively by the corresponding 3 DMX channels. There are two control methods of external control and internal controls, internal controls can be built-in multiple change mode (up to six kinds), external control is to configure the outside controller to achieve color changes, Underwater Lamp the market is also the application of the majority.

3. The underwater lamp uses the best super bright LED as the light source, the bulb can glow for 100,000 hours. Each underwater lamp consists of 360 light sources (120 red, 120 blue, 120 green). The good light source material makes the lamp life longer, and obtains the most satisfactory illumination effect.

4. The underwater lamp is connected with a control system using a five-core line, and the entire system includes a DMX controller, Underwater Lamp a distribution box and a luminaire and distribution that can be placed in water. Perfect combination of the entire lamp.

5. The underwater lamp has an active clamp which can adjust the angle of projection and position. Perfect design for the entire luminaire, Underwater Lamp effectively preventing the erosion of bromine and chlorine

Light

Underwater lamps are generally LED light source, LED is called the fourth generation of lighting or green light source, with energy-saving, environmental protection, long life, small size and so on. When it powers up, Underwater Lamp it can emit a variety of colors, colorful, usually in the park or fountain pool.

Underwater lamps are all imported 1W high-power led for the light source, long life, low power consumption, color purity, non-polluting and other notable advantages. DMX512 control system can achieve a variety of color effects. Long-term immersion underwater work, protection level up to IP68, Underwater Lamp the use of low-voltage DC power supply, safe and reliable, high-quality stainless copper shell, elegant, safe and reliable. With a strong ornamental. The material is generally stainless steel panel, aluminum lamp body, with strong anti-corrosion, strong impact resistance advantages. and has a good waterproof design, simple maintenance, easy installation. The specification is generally between φ80-160mm, the height is 90-190mm.

Basic parameters of underwater lamp:

System structure: The lamp surface, the lamp tube uses the #304 stainless steel cold-rolled and becomes, with the PAR56 bulb, the seal circle uses the waterproof silica gel. Features: Heat-resistant, pressure-resistant, not easy to aging, long life. Scope of application: Swimming pool, massage pool, fountain, koi pond, aquarium and so on. PL series Pl30005–300 W, V, 5 m Wire pl30010–300 W, V, 10 m Wire pl30015–300 W, V, 15 m Wire pl30030–300 W, V, 30 m wire